Settings |
| (Seconds) | |
| () | |
| Apply Settings |
| Idx | Name | Enabled | Type | Address | Port | Data Timeout |
|---|
| Update Delete |
| : | |
|
|
| () | |
| () |
|
|
|
|
|
|
| (etc. /dev/i2c-1, or empty for autodetection) |
| (decimal value) |
| ()
Make sure the correct pin status is read by introducing a bounce delay. |
|
| ()
Maximum of one interrupt per pin allowed in this period (prevents interrupt storms). |
|
| Auto configure devices: | |
|
For DAEnetIP2 boards password field must contain username:password. Example admin:admin |
| CRC message validation: |
Using CRC message validation prevents incorrect data from entering the Domoticz database. |
| Seconds
This limits the amount of meter updates. |
| Poll inputs: | |
| Poll relays: | |
| Poll interval: | Seconds |
| Auto Discovery: | |
| Alarm Inputs: | |
| eHousePRO Enable: | |
|
|
| Change only to select another Toon when having multiple agreements |
| (Seconds) | |
|
Leave the username empty and press the LINK button on the Philips Hue bridge. Then press the 'Register on Bridge' button. |
|
| Register on Bridge |
| You need to sign up at Honeywell to get the API key and secret. Please follow the instructions on domoticz.com/wiki/HoneywellDeveloperApiKey |
|
Select the Topic('s) Domoticz will use to publish outgoing messages. Flat - publish outgoing messagen on topic domoticz/out. Hierarchical - publish outgoing messagen on topic domoticz/out/${floorplan name}/${plan name}. Combined - Use both Flat and Hierarchical topic schemes. None - disable outgoing messages. Note that Hierarchical only reports sensor updates for sensors that are placed on a floorplan/plan. |
|
|
Add extra parameteres to rtl_433 command line. You may for instance :
|
|
Select the Topic(s) where Domoticz publish/receive messages. MyMQTT (default) - domoticz/in/MyMQTT, domoticz/out/MyMQTT Gateway Node Name - domoticz/in/GatewayNodeName, domoticz/out/GatewayNodeName (GatewayNodeName is specified in the Name field (above)) |
|
| (Seconds) This sets the interval between status requests. If you set this to less than 60 seconds you may be in violation of Honeywell's usage terms and have your account suspended! |
|
| Synchronize installation: |
When enabled this will automatically register and keep your zone names in sync with the Evohome controller. |
| Show schedule: |
When enabled this will show the next scheduled switch point when in Auto (FollowSchedule) mode. |
| Show location: |
(implies synchronize installation) |
|
,
,
(keep at [0,0,0] if you only have one Evohome installation) |
|